[pjsip] Using more than one ETH device

[Benny Prijono]

Sorry for the late reply. I just tried this with pjsip SVN version
and couldn't reproduce the problem. Could you post a snippet
perhaps? Also may be better to try the SVN version instead.

cheers,
  -benny


jorge.amador at withus.pt wrote:
> Hi Benny,
> 
> I changed to the 0.7.0 version and succeded adding udp transport on  
> both eth devices. However when I try to lock one account to one  
> transport and another account to another transport (each transport  
> with different IP addresses and ports) it doesn't work. Both accounts  
> get locked to the same transport and it is always the last transport  
> that I configure. I'm using pjsua_acc_set_transport() with the account  
> id that I want to lock to a transport id. Any idea of what is going  
> wrong? Thanks a lot for your help.
> 
> Best regards,
> 
> Jorge Amador
> 
> Quoting Benny Prijono <bennylp at pjsip.org>:
> 
>> jorge.amador at withus.pt wrote:
>>> Hi everyone,
>>>
>>> I'm using pjsip 0.5.10.4 in an equipment that as three Ethernet
>>> devices each one with a IP address. I want to create 2 accounts for
>>> Eth1, 2 accounts for Eth2 and none for Eth0, using the same PJSUA. Is
>>> it possible?
>> Not with 0.5.10.x, and maybe with 0.7 version (or probably the SVN
>> version). In 0.7.x, there is an API to "lock" account to specific
>> transport, with pjsua_acc_set_transport(). And since you can bind
>> transport to a specific interface, effectively you can control which
>> interface should be used by an account.
>>
>> cheers,
>>   -benny
>>
>>> Thanks everyone,
>>>
>>> Jorge Amador