[pjsip] PJSIP in ARM

Olivier Beytrison olivier at heliosnet.org
Thu Nov 8 14:45:19 EST 2007



Andre Brenes a écrit :
> A couples of weeks ago I wrote about this topic, PJSIP in ARM. I'm very
> new for both sides of the coin, PJSIP and ARM, so I have a lot of
> questions, hoping someone can help me. I'm going to explain a little bit
> more about my problem.
> 
> We are using an embedded system base in ARM technology, is an TS-7250
> board. This board comes with TS-Linux. TS-Linux is a compact Linux
> distribution, based on Busybox, ideal for small footprint. Therefore, a
> C/C++ development environment is not installed. For development we can
> use two ways:
> 
>     * use cross-compilation
>     * or boot the board from an USB device with Debian.
> 
> I reading about Disk Space Requirements using PJSIP and found that I
> need about 50-60 MB of disk space to store the uncompressed source files
> and about 30-50 MB of additional space for building each target.
> 
> My questions are:
> My board have just 62M of memory, 32 in NAND flash and 32 of SDRAM. Can
> I use PJSIP?
> 
> If I used cross-compilation do I need to download in my board the source
> files or just the application built in my host computer?

That's it. You download pjsip on another linux box, you make your
software there, and you cross-compile it for ARM. Then you juste have to
copy the Binary file to your board and run it from there. So you won't
need more than 2 or 3 megs of space, depending what you're doing with PJSIP.

> 
> Thanks
> 
> 
> -- 
> André Brene Vargas
> 
> 
> ------------------------------------------------------------------------
> 
> _______________________________________________
> Visit our blog: http://blog.pjsip.org
> 
> pjsip mailing list
> pjsip at lists.pjsip.org
> http://lists.pjsip.org/mailman/listinfo/pjsip_lists.pjsip.org

-- 

 Olivier Beytrison
 Telecommunication Engineer
 Mobile: +41 (0)78 619 73 53
 Mail: olivier at heliosnet.org
 GPG: 0x4FB83528 http://pgp.mit.edu/




More information about the pjsip mailing list